This is a model of Bioneural Gel Packs and their panel from Star Trek Voyager. No measurements were used to make this. Not at all accurate, but better than the nothing else that is out there. The panel is pretty basic as I couldn’t find any really good reference images of one. The gel packs fit in the panel as intended by selecting a pack, grabbing it by the back left bottom “edge of group”, and placing it in the bottom back left corner of the recessed slot. This model includes models found in 3D Warehouse. “bag, IV, 3L” by J. Etterling, “Screws” by Gerry, “Industrial Series – Fittings – Type F Camlock – Male Camlock / Male” by Morbius, “Flying Spaghetti Monster” by Brian, and “1/2” Brass Compression Fitting” by Googler2120.
This is an all inclusive Version 3. I have learned a bit since slapping together my original models. Those are not grouped together properly and contain random unnecessary geometry. I would not use them, and may delete them.
- Comments
