This is a loading ramp made with 8' - 2x4's, Polyolefin Wheels, 3" x 1/4" bolts with washers and 2 nuts jammed together. The cross braces are put in with construction adhesive and 3 inch screws. The runners are covered with a strip of 1x 1/8" thick aluminum, . 3" stainless steel screws go through the aluminum into the runners on both sides of each wheel. This was made for less than $100 (including construction adhesive and the cost for all the parts). Thank you to other model makers for the use of the Chevy Silverado and other components
- Comments
